Warranty

All Standard Warranties are subject to the following terms and conditions listed below:

1. Baseline 4x4 Recyclers Inc. warrants all parts purchased for 90 days. Any and all warranties apply to the original invoice and purchaser. Warranties are not transferable.
2. Engines are covered under the standard warranty for a period of 90 calendar days. The standard engine warranty covers the rotating assembly along with all lubricated parts such as engine block, cylinder head and valves, lifters, cam shaft, connecting rods and bearings, pistons and rings, oil pump, crankshaft and bearings.
3. The standard engine warranty does not include any parts external to the rotating assembly including carburetors, water pumps, fuel pumps, intake manifolds, exhaust manifolds, plugs, wires, distributors, fuel injectors, timing belts, oil pans, all gaskets and seals. These items are not warranted when sold on an engine and often need to be switched over from the original engine. On engines with belt driven timing components (belt and tensioner) must be replaced prior to install.
4. All engine warranties are void if heat tabs are melted or removed. The standard operating engine temperatures are critical. Any temperature above factory recommendations will cause permanent damage.
5. All engine fluids are drained when removed from the vehicle. Purchaser agrees to have new oil and a new filter installed including engine coolant in accordance with the manufacturer's recommendations upon engine installation or warranty will be void.
6. Transmissions are warranted to be in good working order for a period of 90 days, against slippage and shifting failure if properly installed. All transmissions are sold without fluid. The seals and filter, if equipped, must be replaced. If a transmission is returned and a new filter has not been installed, then warranty is void and no refund will be given.
   
   Transmission lines and transmission coolers must be flushed to purge all contaminants from the cooling portion of the transmission. If they are not, the warranty is void. The transmission is to be filled with the original manufacturer's recommended fluid. Speed sensors are not warranted and must be replaced, by the buyer, if found defective. If the transmission is electronically controlled, the system must be programmed to allow proper operation. Most late model transmissions require programming, (please consult your shop manual or shop software for programming requirements. Proof of programming will be required in the event of failure.) Failure to follow these instructions will result in a null and void warranty. All automatic transmissions purchased must be professionally installed. (Must provide receipt) Failure to do so voids warranty. Transmission returns, including cores, must be returned complete. All internal components must be present including valve body, solenoids, clutch packs and gears.
7. Transfer cases are warranted to be in good working condition to include all internally lubricated components for a period of 90 days. Standard items included but not limited to are front and rear cases, input and output shafts, reducing cluster assembly, shift forks and rails, gear assemblies and chain. All fluids are drained at the time of removal. The transfer case must be serviced with the original manufacturer's recommended fluid. No externally mounted components are covered under this warranty.
8. Axles are warranted to be in good working condition to include all internally lubricated components for a period of 90 days. Standard items included but not limited to are all inner and outer axle shafts, ring and pinion gears and carrier.
   
   All fluids are drained at the time of removal. The axle must be filled with the original manufacturer's recommended fluid to the specified limit. Axle shaft u joints and hub assemblies are considered wearable items and are not covered by this warranty. No externally mounted components are covered under warranty.
9. All parts, mechanical, electrical and body parts, must be returned in the same condition as they were at the time of sale. Any changes or modifications to the part after the sale will void the warranty.
10. All claims must be accompanied by the original sale receipt. All standard warranty claims must be presented within a period of 90 days from the date of purchase for the warranty to be valid.
11. Baseline 4x4 Recyclers, at our discretion, maintains the right to either repair or replace the failed components. In some cases we may request that the item be returned and refund the original purchase price of the item.
12. All implied warranties are limited to the terms and conditions of this standard limited warranty. Consequential or incidental damages are not covered under
    this warranty. This warranty is not transferable and does not cover damage. All tires are sold as-is, no warranty and buyer assumes all risk.
13. Improper installation of any assembly will void any and all warranties.
14. No labor coverage is included with the standard limited warranty.
15. Fleet and commercial vehicles are not covered under this warranty.
16. Baseline 4x4 Recyclers Inc. does not assume any responsibility for towing charges, loss of use, down time, cost of lodging, cost of vehicle use, inconvenience or rental vehicle or Consequential Damages.

Baseline 4x4 Recyclers Inc. does offer extended warranties. These are purchased separately at the time of original purchase. Items covered under the extended warranty will be attached to the original invoice for the parts and labor that are covered. No other warranty terms will be changed. All replacement parts and repairs must be approved by Baseline 4x4 Recyclers Inc. before any work is performed. Failure to do so will void the warranty. It is Baseline 4x4 Recyclers Inc. option to approve the necessary labor to replace or reinstall defective parts. All such warranty work must be performed by an Authorized Agent of the Seller.

DO NOT REMOVE INSTALLED PARTS SUCH AS ENGINES AND TRANSMISSIONS WITHOUT RECEIVING PERMISSION FROM THE SELLER. Doing so may void your warranty. AIl warranty claims must be made within 15 days of part failure. Labor reimbursement will not be paid on returned parts.

Silver Warranty
The Silver Level Warranty covers everything listed in the Standard Warranty and extends coverage to 180 days from the date of purchase.

Gold Warranty
The Gold Level Warranty covers everything listed in the Standard Warranty and extends coverage to 365 days from the date of purchase including labor. Labor rates are calculated under the standard shop repair program of our choice.The maximum labor charge is limited to $75.00 per hour.

All warranty claims and returned goods must be accompanied with the original invoice. All correctly filled orders which are returned will be charged a 35% restocking fee along with the original shipping costs if ordered online. Parts must be returned within 15 days of purchase. No refunds will be issued on special ordered items or cut items. CORES MUST BE RETURNED WITHIN 30 DAYS TO BE ELIGIBLE FOR REFUND. Cores must be returned drained of all fluids and rotating assemblies must turn freely. The block or case must not be broken, and must be complete with all accessory parts for a full refund. Transmissions and transmission cores must be returned with converter and valve body. The case must be complete and not cracked or damaged in any way. The transmission pan must be attached. Cores returned and not drained are subject to a $50 fluid disposal fee. All returns will be refunded by the same method as originally paid for. Refunds can take up to 15 days to process. All returned cores will be refunded by the original payment method. Please allow 15 days for refunds to be processed.

Returns and Warranty Claims require prior authorization. All items returned without prior authorization will be refused and will not be warrantied or refunded.